Does anyone have a barbed wire brush?
-Ed.
Does anyone have a barbed wire brush?
-Ed.
The Brush
Egg
Minis Forum UM780XTX AMD Ryzen7 7840HS with AMD Radeon 780M Graphics + 32 GB Ram + MSI Optix Mag321 Curv monitor + 1Tb SSD + 232 GB SSD + 250 GB SSD portable drive + ISP = BT + Web Hosting = TSO Host
THANKS Egg, that's a mighty cool brush there!! http://www.talkgraphics.com/images/smilies/cool.gif
Richard http://www.talkgraphics.com/images/smilies/wink.gif
http://www.ramwolffsworld.com//Publi..._Prowl_sig.gif
http://www.ramwolffsworld.com/RAMWolffsWorld
Richard
---Wolff On The Prowl---
I couldn't resist.
Thanks, Egg.
.joroho.
http://www.joroho.com/initials.gif
Wise men still seek Him.
Well that saves me a job Eric, is it OK to post these in the swap shop.
Christine
Christine
Software: XDPX9, WD9,WD10,XDPX10,WD11,XDPX11,XDP365
Not a true barbed wire brush but probably adaptable at Tinsel brush
I'll see if I can do a more approriate one later today.
Christine
Christine
Software: XDPX9, WD9,WD10,XDPX10,WD11,XDPX11,XDP365
Ed
I always like a challenge. Here's my attempt.
Egg
[This message was edited by Egg Bramhill on January 23, 2004 at 20:16.]
Egg
Minis Forum UM780XTX AMD Ryzen7 7840HS with AMD Radeon 780M Graphics + 32 GB Ram + MSI Optix Mag321 Curv monitor + 1Tb SSD + 232 GB SSD + 250 GB SSD portable drive + ISP = BT + Web Hosting = TSO Host
Simply Fabulous! http://www.talkgraphics.com/images/smilies/cool.gif
Egg ... You have once again FAR exceeded all expectations. Nice Brush! It will work perfectly for my western themed project. By the way, this is a volunteer project (which describes most of my work). I would never ask for freebies on a compensated project. Thank you very much. I owe you.
-Ed.
Bookmarks